FIRST RUBBER
Medical infusion cap from China manufacturer
Published:
Jun 09,2022
Classification:
Medical infusion cap from China manufacturer, including a body made of ABS plastic cap and lining, with fixing straps on both sides of the bottom of the body, support rod seats oinfusion cap from China manufacturern the outer sides of the ears on both sides of the body, and U-shaped telescopic rods in the support rod seats , The upper end of the U-shaped telescopic rod is provided with a frame-type hook frame, the middle of the upper crossbar of the frame-type hook frame is provided with a hook, and the lower crossbar of the frame-type hook frame is connected with the U-shaped telescopic rod crossbar. There are fixed rods installed at both ends, the top and middle of the fixed rod are provided with bayonet openings, and the middle of the vertical rods on both sides of the frame hook frame and both ends of the hinge are provided with bayonet pins. When using infusion cap from China manufacturer for infusion, Pull the U-shaped telescopic rod upwards, tighten the stopper pin, and the frame-shaped hook frame is in a vertical state.
The above is a brief introduction to the relevant knowledge of medical infusion cap from China manufacturer.
Tel: +86-0311-89197800
Hotline: +86 151 2277 7167
E-mail: inquiry1@desheng.net
Add：No. 518, Zhengding Technology Industrial Park, Shijiazhuang City, Hebei Province, China